iVend Retail – iVend Report (Designer) Timeout

Follow the steps mentioned below to set the timeout property in iVend Report Designer:

1. Open the Management Console, go to: Reports > Designer/Label > Report Designer

Figure 1 Report Designer

2. Open the report that is experiencing the timeout issue and from the Dictionary tab, select the Data Source, then right-click and select Properties.

Figure 2 Report Designer -Dictionary

3. On the Properties tab, "Command Timeout" property, the default value is 30.

Figure 3 Report Designer Properties

Figure 3

4. Change this default value as required. The time unit for the Command Timeout property is in seconds.

Note: Specify the value as 0 for unlimited time.

​

Figure 4 Report Designer -Command Timeout

Figure 4

5. After you have completed the desired changes. Click [Ok] to save the changes made in the report.